Extractor
Fitting was easy worked perfectly
Extractor for Colt/Para w/ FP Blocks, .45 ACP, Series 80, by Dawson Precision®
(4 reviews)
Write A Review
Write a Review
Extractor for Colt/Para w/ FP Blocks, .45 ACP, Series 80, by Dawson Precision®
Description
Replacement part for 1911 single and double stack pistols.
- FOR USE WITH 1911 and Para® hi-cap pistols.
- Proudly made in the U.S.A. from high quality steel to exact tolerances.
- Available in a Stainless Steel finish.
Reviews
-
-
Great Value
Purchased for a 9mm Kimber Stainless II. Finish was very good, the slot for the firing pin stop required some minor fitting (10 minutes using 220 grit sandpaper over a hard straight edge). Works perfectly and looks good! H
-
Great service
I called with a problem. No one had a replacement for a Para P-14 extractor. Not only did I get advice on what part to replace it with, I received it the next day!! I will call Dawson first, next time I need such products.
-
Flawless fit in Para P18.9 (old generation)
I purchased this extractor due to uncurable extractor problems with the one in the gun. It appears a previous owner had tinkered with it. This replaced the two-piece extractor (NOT the "power extractor" model) which came factory in the P-18.9. It fit perfectly in the channel and after some tensioning and shaping/radiusing of the extractor claw (per standard protocol) this thing worked flawlessly in my Para. I was particularly pleased because the original two-piece factory extractor is no longer available and it was a relief when I found out this fit.
